Operation Manual

CE Mark Warning

This is a Class A product. In a domestic environment, this product may cause radio interference,

in which case the user may be required to take adequate measures.

Installation Safety Notes

 Do not place the Niagara Video appliances underneath heavy loads or in an unstable

position.

 Do not expose the Niagara Video appliances under direct sunlight, high humidity or wet

conditions.

 Do not use or expose the Niagara Video appliances around magnetic fields as magnetic

interference may affect the performance of the device.

 Do not block the air vents to this device or impede the airflow in any way.

READ THE FOLLOWING SAFETY INFORMATION THOROUGHLY BEFORE

INSTALLING THIS NIAGARA VIDEO PRODUCT. FAILURE TO FOLLOW THIS

SAFETY INFORMATION MAY LEAD TO PERSONAL INJURY OR DAMAGE TO THE

EQUIPMENT.

Power Supply

 This unit must be grounded.

 The unit must be connected to a grounded outlet to comply with product safety standards.

 The grounded socket-outlet shall be installed near the equipment and shall be easily

accessible.

 Do not connect the power supply unit to an AC outlet without a ground connection.

 All power cords must be disconnected before servicing.

Power Cords

The plug on the power supply cords is considered to be the equipment disconnect device and

must be approved for the country where it is used.

Important Safety Information! Please note the following:

1. The Niagara Video B264 is intended for indoor use only.

2. In case of emergency, disconnect the power cords.

3. If power cords are not provided:

 In the United States, use standard computer power cords (as

specified below).

 In Europe, for 230 volt operation, use a cord set marked “HAR”

and consisting of a min 3 core H05VVF3G075 cord that has a

minimum 0.75 square mm diameter conductors, provided with

an IEC 320 receptacle and a male plug for the country of

installation, rated 6A, 250V.

4. Do not block the equipment vents.