Operation Manual

49
SCTE 104 Ad Insertion Triggers
If the input signal is SDI, the B264 is capable of extracting SCTE 104 triggers from the VANC
(inserted as per SMPTE 2010) and converting them to SCTE 35 triggers in the output transport
stream:
 Enable SCTE 104/35: Check this box to enable SCTE 104 extraction. Note that this
control is only displayed if the input signal is SDI or if the encoder is in auto-detect video
mode.
Advanced Tab – Audio Parameters
The Audio Parameters are divided into three subgroups, some of which vary (and may not be
present) according to the selections made in the various audio configuration sections in the
Encoder Basic Configuration Tab and the installed rear I/O panel. A sample of the Audio
Parameters section is depicted below.
Analog Audio
Parameters
PMT Information
Audio Encoder
Specific Configuration
A/V Sync Adjustment