Operation Manual

IP Inputs
156 ViewCast
Video tab
Use the following table to configure the video IP input settings.
Figure 164. Video tab
To configure IP ingest video settings:
1.
Select IP Ingest from the drop-down list.
2.
The Address and PID fields display under the Source field (Figure 165). Select the desired
protocol from the drop-down list in the Address field.
Figure 165. Address and PID fields
Note: UDP and RTP are currently the only two protocols supported.
3.
Enter a valid IPv4 address in the textbox to the right of the Address field.
4.
Enter a valid port in the far right text box. The port should be between 2- 65535 including 2
and 65535. The IP source streams to this port. Once entered, the Detect button is enabled.
5.
Click Detect. While the system is detecting the IP stream, all of the IP Ingest controls are
disabled (Address and PID fields). The Detect button displays Detecting and a red working
icon spins to show that detection is occurring. This process may take as long as 30 seconds.
During this time, the UI is unresponsive. When the detection is complete, if an IP source was
detected at the provided IP address and port, it displays in the PID dropdown list (Figure
166).