Operation Manual

Niagara 9100 Series User Guide
ViewCast 65
Output tab
Use the following table to configure the output analog input settings for a Flash encoder.
Note: The choices in the drop-down list may vary.
Figure 59. Output tab
To configure output settings:
1.
Select Enable Streaming to enable live Flash streaming.
2.
Enter the proper IP address in the Server Address field.
3.
Enter the Stream Name.
4.
Select the Authentication Type from the drop-down list. Options are available for streaming
directly to Adobe, Akamai, and Limelight CDNs.
5.
Enter the User Name and Password.
6.
Select the Embed System Time as Timecode.
7.
Click the Frame Interval from the drop-down list.
8.
Enable Save to File to save the encoded content to a file. Each time you start this encoder, the
system overwrites the previous file.
Note: You must enable either Enable Streaming or Save to File. If both Enable Streaming
and Save to File are disabled, the encoder will not start and an error is generated.
9.
Select Create unique file to create a file that the system does not overwrite.
10.
Accept the default location that displays in the File Name field or choose your own location
for the file. To choose your own personal location select the link (horizontal ellipses or … ) to
the right of the File Name field and display the options (Figure 60).
Note: By default, the system sets this folder to D:\AVFiles with a default file name of