Operation Manual

Advanced Operations
64 ViewCast
Audio tab
Use the following table to configure the audio analog input settings for a Flash encoder.
Note: The choices in the drop-down list may vary.
Figure 58. Audio tab
To configure audio settings:
1.
In the Source field, select an audio source from the drop-down list.
IMPORTANT! The audio input must match the source connected on the back of the system and
your audio source.
2.
Click the audio Format from the drop-down list.
3.
Click the Bitrate from the drop-down list.
4.
The Audio Encoder setting is AAC.
5.
Drag the sliders to adjust the Left Volume and Right Volume.
6.
(Optional) Select Mute Audio to silence audio.
7.
Click Save Settings.