Operation Manual

Advanced Operations
60 ViewCast
Adobe Flash H.264 encoder with analog inputs
To create an encoder, Encoders  All Encoders  Create New Encoder link  Encoder Name field.
When you create a new encoder, the Encoder Properties window appears. The steps for editing a new
encoder or an existing encoder are identical. You must configure the video and audio settings for each
encoder type.
Use the Video, Audio, Output, and H.264 Presets tabs to edit the settings. Begin with configuring the
video and audio settings, then the server and destination settings. The server and destination settings
are different for each type of encoder.
From the Encoder Properties window (Figure 53), you can set the encoder to start streaming
automatically by selecting the Auto Start check box. You can also start an encoder from this window by
clicking the Start Flash Encoder link in the top right corner of the window.
IMPORTANT! If you make any changes to the Encoder Properties window, you must click Save
Settings. Otherwise, all your changes will be lost.
Figure 53. Flash encoder