Operation Manual

Advanced Operations
146 ViewCast
Figure 152. Output tab
To configure output settings:
1.
Click on a Windows Media Capture Profile from the drop-down list.
2.
Select Enable Pull.
3.
Enter a port number that the server will use to pull the stream.
4.
Select Enable Push.
IMPORTANT! Be sure to enter a port number not already assigned to another encoder. If
two encoders attempt to use the same port number, one or both encoders will fail to start.
5.
Enter a port number that the server will use to push the stream.
6.
Enter the Server name or IP address.
7.
Enter the Alias.
Note: This field is optional.
8.
Enter the User Name.
9.
Enter the Password.
10.
Select Enable Scripting to embed closed captions.
Note: If you enable closed captions through the Osprey driver, you cannot enable scripting.
11.
You can either:
 Click the Save to File check box to save the encoded content to a file. Each time you start
this encoder, the system overwrites the previous file.
 Click the Index the file to drag the slider to any point in your video capture.
 Click Create unique file to create a file that the system does not overwrite.