Operation Manual

Advanced Operations
122 ViewCast
Audio tab
Use the following table to configure the audio digital input settings for a Flash encoder.
Note: The choices in the drop-down list may vary.
Figure 124. Audio tab
To configure audio settings:
1.
In the Source field, select an audio source from the drop-down list.
IMPORTANT! The audio input must match the source connected on the back of the system
and your audio source.
2.
Click the audio Format from the drop-down list.
3.
Click the Bitrate from the drop-down list.
4.
Click the Audio Encoder from the drop-down list.
5.
Grab and drag the slider to adjust the Left Volume and Right Volume.
6.
(Optional) Select the Mute Audio check box to silence audio.
7.
Click Save Settings.