Users Manual

If the FCC ID is not visible when the module is installed inside another device, then the
outside of the device into which the module is installed must also display a label referring
to the enclosed module. This exterior label can use wording such as the following:
"Contains FCC ID: 2AUP7-N80".
The module is intended for Host product manufacturer only. Please see the full grant of
equipment document for restrictions. The module cannot be co-located with any other
transmitters except in accordance with FCC multi-transmitter product procedures.
The module is only FCC authorized for the FCC part 15.247 rules (listed on the grant), and that
the host product manufacturer is responsible for compliance to any other FCC rules that apply
to the host not covered by the modular transmitter grant of certification.
The Host product manufacturer should make test on the product with module to confirm that
the host product meets the FCC part 15.247 rules. This investigation of the final product can be
done by spot checking emissions from the device while paired with another Bluetooth
companion one as per the normal intended use (For example, data transfer, music playing, etc.),
to check the fundamental-frequency and spurious emissions for compliance.
To satisfy FCC RF exposure requirements, a separation distance of 20 cm or more
should be maintained between antenna radiating structures of host product and persons during
device operation.
The Host product manufacturer should add such caution in the user manual of the device into
which the module is installed.
This device should be only used by Host product manufacturer, without RF power increasement
(Antenna applied: PCB, 2.42dBi max.)
nor antennas type modification.