User Manual

Insure that the voltage is 6v or less to the
ignition.
II.) Connections:
Check that all connections are correct from
the battery, to the switch, to the ignition.
Use a volt meter on the switch to ensure
the ignition is getting power and the
polarity is correct.
III.) Hall Effects Sensor:
Ensure that the orientation of the hall
sensor is correct with the orientation of
your hub magnet. If you used your
existing hall sensor, make sure that the
wire orientation (fig. 4) is correct.
5.) Safety Precautions.
Never power the ignition with the plug in the head
when you’re working on your engine, it could fire
off!! Always wear a glove when starting your
engine!! After turning off your ignition, beware that
the ignition could still have a charge and fire the
motor. Always range check your model!!
Copy Right, RCEXL Inc. 2007
M E -8
CM-6 Y82
Ri mfir e 1/ 4x 32
C MR 7A BP MR6F
BMR7A