User Manual

2
Engine connection:
Following the above pictures, connect the engine, carburetor and oil tank, etc. It is strongly recommended to use high
temperature resistance, gasoline soft tube and its bore diameter is 2 mm. The tube connects with oil nozzle if necessary
uses clamp, let the oil tank farther from the engine and you can wrap the tank with a sponge to prevent the occurrence
of air bubbles.
Must pay attention when install the propeller blade mat of the magnet relative to the Angle of the top dead center
position, difference between 180 degrees wrong position can cause engine does not work.
Carburetor：
①—Air inlet； ②—High speed needle(HSN)； ③—Low speed needle(LSN)； ④—Inlet nozzle；
⑤—Suction nozzle； ⑥—Throttle control arm
Carburetor initial setup:
High speed needle：Completely closed before exiting 1.5 turns; Low speed needle：According the initial setup factory ;
Idling start time the air inlet: According the “View 2”