User's Manual

Nexxt Solutions - NexxtGate150 Access Point
2.4 Checking the LEDs
Upon powering on your access point. verify that the
PWR and
WlAN LEDs light up orange.
3. Location of the access point
Before making any hardware connections, find a
suitable location
to place the access point. The best
spot is usually
at the center of the wireless network,
with unobstructed line-of-sight
to all wireless clients
operating
in the coverage area.
Also consider
that the higher the antenna is placed, the
better the device can perform.
Do not forget to make
sure
that the structure or pole you use to install the
device is stable and properly secured.
1. If setting up the device in an indoor installation, use
the keyholes
on the brackets to mark the location on
the wall where the access point is to be mounted.
2. Drill the holes and then drive the supplied anchors
[if required] and screws into the wall. Leave the head
of the screw slighgtly above the surface
to hang the
access point from the keyholes
on the back.
wall
5