User Guide

North American color code standard:

White is for neutral, black represents the live and load wires,

the green/yellow cable is for grounding and the red cables

are for traveler one and traveler two.

Note: a single bare copper wire is also used to represent

the ground wire in existing electrical installations.

Step 3

Label the wires

Mark the corresponding cables before removing the

existing light switch.

Always follow code standards when installing wired

connections.

Note: All the images are for reference only and therefore,

they must not be used as a standard.

Step 4

Mount the smart switch

- The installation only requires one smart switch per

electrical circuit.

- Using the correct polarity, match each wire from the smart

switch with those coming from the junction box.

Note: make sure that there is no wire exposed.

a. Single 3-way switch installation

Make sure to follow the wiring conﬁguration:

1) Connect the wire ends of each pair into the wire nut,

then twist each nut full turns until the connection is fully

secured. Repeat this step for each cable assembly.

Traveler (T1 or T2)

Traveler

(T)

(Hot Wire)

Live Wire

Traveler

(T)

Ground

(G)

Common

(C)

Traveler (T1 or T2)

Ordinary 3-Way Switch

Ground Wire