User's Manual

Nexxt Solutions - ACRUX - Wireless N Gigabit Router
107
To add static routing entries:
1. Click the Add New button as shown in figure
4-59. The following screen will open.
2. Enter the following data:
Figure 4-60 Add or Modify a Static Route Entry
Destination IP Address - The Destination IP
Address is the address of the network or host
that you want to assign a static route to.
Subnet Mask - The Subnet Mask determines
which portion of an IP Address is the network
portion, and which portion is the host portion.
Gateway - This is the IP Address of the gateway
device that allows for contact between the router
and the network or host.
3. Select Enabled or Disabled for this entry from
the Status pull-down list.
4. Click the Save button to make the entry
take effect.
Other configurations for the entries:
Click the Delete All button to erase all entries.
Click the Enable All button to activate all entries
Click the Disabled All button to cancel all entries.
*
*
*