User's Manual

Nexxt Solutions - Integrated Wireless IP Camera with IR Cut-Off Filter
44
When you finish filling out all the information, click
the add button below to save all these configuration
values in the camera. Note: multi- camera view is
currently supported only by IE.
Basic Network Settings
Use this menu to set the IP camera’s IP Address,
subnet mask address, gateway, DNS server, HTTP
port, and RTSP port if settings are not being
acquired through a DHCP server. Otherwise,
enable “Obtain IP from DHCP Server” option as
seen below:
Wireless LAN (Wi-Fi) Settings
The following image exhibits the wireless connection
device. There are five kinds of security modes: WEP,
WPA-PSK and WPA2-PSK. When accessing the
Internet wirelessly, the camera’s SSID must be the
same as the wireless AP device’s number.
If the wireless router is currently running, first
connect the network cable to the IP camera and
open the camera’s page through the computer via
the web browser, then enter the device’s interface
under wireless LAN (Wi-Fi) settings. Click the Scan
button; the camera will start looking for radio
signals. After the search is completed, choose
the wireless router which is needed to connect. If
authority verification has been set, input the login
password, followed by the “submit” button to save