REV. A ECO No. First release APPROVED NAME SIGNATURE NAME DATE SIGNATURE DESCRIPTION: Product Manager R&D Manager INSTALLATION GUIDE REPEATER RX-TX Testing Manufacturing Eng. Shay Aharon QA Engineering Shay Aharon SH 1 OF DRAW No. DC00019-001 REV.
DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.
Table of Contents Mechanical Assembly Description............................4 PCB ...........................................................................4 Front Box ...................................................................4 Gland .........................................................................5 Assembly Pcb ............................................................6 Cover Pcb..................................................................7 Label..................................
Mechanical Assembly Description FCC Warning Modifications not expressly approved by the manufacturer could void the user authority to operate the equipment under FCC Rules. In order to comply with FCC RF Exposure requirements, the AMR unit must be installed in such a way that there is a 20 c”m separation distance between it and all persons during normal operation. Front Box Attach standoffs with plain washer, nut and spring washer to the lower board. DRAW NO.
Attach the lower board into the front box and assemble screws. Gland Assemble gland with nut and washer. DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.
Assembly Pcb Assemble the Pcb into the front box and hold it with standoffs, screws, and washers. DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.
Cover Pcb Place the RF shield above Pcb and assemble screws and washers. Label DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.
Place warning label on top of the RF shield. DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.
Antenna Place the antenna and assemble plastic screws. Mounting Place the bracket and tighten with screws. DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.
AC Cable place the AC cable into the front box DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.
Assemble AC cable with screws Top Cover Place the top cover on the front box and assemble screws. DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.
Sealed the top cover with strips. Final assembly DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.
DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.
