Manualshelf

Installation Guide

ManualsBrandsNexus21 ManualsAV Mount / AV BracketNexus 21 In-Wall Pull Down TV Mount 4-Way Swivel for 55" to 75" TV
12345678910
8
Mounting To Wall
Note: The person installing the mount should be a competent
person with experience mounting load bearing assemblies.
1. Once you know your location, draw a 26.25” tall x 13.2”
wide rectangle centered horizontally on the TV as shown in
Figure 8.
2. Cut a hole along the lines.
3. You’ll need a friend for the next steps.
4. Put the Mount in the hole, have someone hold the mount so
the drywall is not taking all of the weight.
5. Pre-drill 1 of the top row of mounting holes 2.5in deep using
the 1/4" drill bit.
6. Figure 8 shows the correct order to put on the lag screw.
7. Use a 9/16” wrench to install the lag screw; do not tighten
all of the way down yet.
8. Level the mount as shown in Figure 7.
9. Mark and drill the other 3 holes 2.5” deep.
10. Install the lag screws and tighten until the mount is firmly
pressed against the wall. Do NOT over tighten.
Figure 8, Attaching to Wall
Attaching Vertical Mounting Bars to Television
Figure 9, Attaching Vertical Mounting Bars to TV
We recommend putting a
spacer between the Vertical Bar
and the TV to avoid scratching
the TV.
Use the metal washer with the
M6 screws.
Use the right screw and spacer
combination to get maximum
thread engagement without
bottoming out the screw.
RIGHT!
Screw Clamps TV
to Vertical Bar with
maximum thread
engagement.