Installation Guide

6
Figure 4, Maximum Swivel
Attaching Screen Back Plate to Mount
The Screen Back Plate needs to be attached to the Mount before anything else can be done.
Attach through the holes shown in Figure 5. Slide the Swivel Pivot Bolt through the holes
and washers from the top as shown in Figure 6. Do it from the top so that even if the nut
comes off, the Bolt cannot slide out because of gravity.
Some holes may be tight, if so gently hammer the bolt through. Tighten the Swivel Pivot Nut
down with a 1/2 inch wrench until all the parts are compressed together and the Screen Back
Plate takes a little effort to turn, you can adjust this effort after the TV is mounted on the
wall. Use the 1/2 inch Open-Ended Wrench, which came with the mount, to hold the head of
the Swivel Pivot Bolt whole tightening.
Figure 5 Swivel Holes (Top View of Mount)
Adjusting the Swivel Tension
After everything is mounted to the wall; the TV is hung on the mount; and the
counterbalance and tilt are set, the amount of effort it takes to swivel the TV may need to be
adjusted. You do this by tightening or loosening the Swivel Pivot Nut on the Swivel Pivot
Bolt. Access is easiest when the mount is in an out position. Do NOT over-tighten; if it takes
a lot of force to turn the nut then the pivot is as tight as it can be, if you tighten more you will
start to bend the mount. For all swivel settings, if the TV doesn’t stay in the wanted swivel
position, even after the pivot is tightened, the mount may be tilted too much, adjust tilt nearer
to vertical.
Figure 6 Swivel Bolt
(Side View of Mount)
Screen Back Plate