Installation Guide

2
Screen Back Plate
Transcend In-Wall Mount
Vertical Mounting Bars
Contact: [e-mail]
Toll Free: [phone]
Phone: [phone]
Fax: [phone]
Revised: 10/6/16
Below is a parts list describing all of the items included with the Transcend In-Wall Mount.
Before beginning assembly and installation, please make sure that you have all items included on the list. If
any parts are missing or damaged, please contact Nexus 21. Our contact information is shown at the top of
this page.
Parts List
Contents of hardware pack that is labeled “Transcend In-Wall Hardware”
• 4 3/8 inch by 3 inch long lag screw with washer
• 4 Zip Ties
• 2 Adhesive Rubber Bumpers (Stick these to the mount to help protect the Shelf)
• 1 1/2 inch Open-Ended Wrench (For attaching Screen Back Plate)
• 4 Lag Screw Cover
• 4 Washer for Lag Screw Cover
• 1 5/16 inch diameter x 7 inch Hex Head Machine Screw (Swivel Pivot Bolt)
• 1 5/16 inch Nylock Nut (Swivel Pivot Nut)
• 2 5/16 inch Washers
Assorted TV Mounting Hardware Pack
• 4 M6 x 20 mm (.78in) long Phillips head machine screw
• 4 M6 x 35 mm (1.38in) long Phillips head machine screw
• 4 M8 x 20 mm (.78in) long Phillips head machine screw
• 4 M8 x 35 mm (1.38in) long Phillips head machine screw
• 8 1/4 inch tall plastic spacers
• 4 1/8 inch tall plastic spacers
• 4 Steel M6 washers
------------------------------------------------------ END OF PARTS LIST ------------------------------------------------------