Installation Guide

13
Setting the Tilt in the Top Position
In the top position the mount tilts from vertical to about 7 degrees
(Figure 2 and Figure 3). To set the angle, put the mount in the out
position for easier access and so there isn’t any force on the cam.
Adjust the Top Tilt Cam by removing the top Tilt Adjustment Bolt
(Figure 17) and putting it into a different set of holes and hand
tighten with one nut. Approximate tilt settings are shown in Figure
18. There is a cam on both sides of the mount, use the Top Tilt
Alignment Marks and holes to ensure they are at the same position.
Move the mount up and see if the tilt is correct, if not change the
position of the cams, it will probably take a few times to get the tilt
perfect. If you get a lot of resistance when trying to push the mount
to the Top position, the Cam is set for too much up tilt and you will
need to lessen it. Once you have the desired position, tighten both
nuts with a 7/16 inch box wrench and phillips screwdriver.
Setting the Tilt in the Bottom and Out Positions
In the bottom and out position the mounts tilt can be set Vertical +/-1
degree. To adjust, loosen up the 2 Bottom Tilt Lock Nuts with a 7/16
inch box wrench. Next move the 2 Bottom Tilt Adjustment Bolts in
and out with the 7/16 inch box wrench until the mount is at the
desired tilt, lock down the locknuts when satisfied with the tilt.
Figure 17, Tilt Adjust Hardware
Figure 18, Top Tilt Cam Settings