User's Manual

of waste.

1 Getting Started

1.1 Getting to know your touch phone

1.2 Installing the SIM card, battery, and storage card

You need to remove the back cover before you can install the SIM card and

battery. Also, make sure to always turn off the power before installing or

replacing the SIM card and battery.

To remove the back cover

1. Make sure your device is turned off.

2. Firmly hold the device with both hands and the front panel facing down.

3. Push the back cover up with your thumbs until it disengages from the device

and then slide it up to remove.

To remove the battery

1. Make sure your device is turned off.

2. Remove the back cover.

3. The bottom of the phone has a notch. Lift the battery by the notch to remove

it.

To install the SIM card

The SIM card contains your phone number, service details, and phonebook/

message memory. Your device is supported 2G, 3G (WCDMA) ， 4G

（FDD-LTE ）

1. Remove the battery if it is installed.

2. Locate the SIM card slot, and then insert the SIM card with its gold contacts

facing down and its cut-off corner facing out the card slot.

3. Slide the SIM card completely into the slot.

Note: • The phone can be supported the single SIM card. The card slot will

be supported 4G (FDD-LTE).

• Some SIM cards may not function with your device. You should consult

with your service provider for a replacement SIM card. There may be fees

for this service.

To install a memory card