User's Manual

based on standards that were developed by independent scientific organizations

through periodic and thorough evaluation of scientific studies. The standards

include a substantial safety margin designed to assure the safety of all persons,

regardless of age and health. The exposure standard for wireless mobile phones

employs a unit of measurement known as the Specific Absorption Rate, or SAR.

The SAR limit set by the FCC is 1.6 W/kg. * Tests for SAR are conducted with

the phone transmitting at its highest certified power level in all tested frequency

bands. Although the SAR is determined at the highest certified power level, the

actual SAR level of the phone while operating can be well below the maximum

value. This is because the phone is designed to operate at multiple power levels

so as to use only the power required to reach the network. In general, the closer

you are to a wireless base station antenna, the lower the power output. Before a

phone model is available for sale to the public, it must be tested and certified to

the FCC that it does not exceed the limit established by the government adopted

requirement for safe exposure. The tests are performed in positions and

locations (e.g., at the ear and worn on the body) as required by the FCC for each

model. The highest SAR value for this model phone when tested for use at the

ear is 0.534W/Kg and when worn on the body, as described in this user guide, is

1.043W/Kg(Body-worn measurements differ among phone models, depending

upon available accessories and FCC requirements). The maximum scaled SAR

in hotspot mode is 1.185 W/Kg. While there may be differences between the

SAR levels of various phones and at various positions, they all meet the

government requirement for safe exposure. The FCC has granted an Equipment

Authorization for this model phone with all reported SAR levels evaluated as in

compliance with the FCC RF exposure guidelines. SAR information on this

model phone is on file with the FCC and can be found under the Display Grant

section of http://www.fcc.gov/ oet/fccid after searching on

FCC ID: 2AHDFGO1402 Additional information on Specific Absorption Rates

(SAR) can be found on the Cellular Telecommunications Industry Asso-ciation

(CTIA) web-site at http://www.wow-com.com. * In the United States and

Canada, the SAR limit for mobile phones used by the public is 1.6watts/kg

(W/kg) averaged over one gram of tissue. The standard incorporates a