Manual

www.nexusrobot.com Robot Kits manual
8
7 | Select your board
You'll need to select the entry in the Tools > Board menu that corresponds to your Arduino.
For Duemilanove Arduino boards with an ATmega328 (check the text on the chip on the board), select
Arduino Duemilanove or Nano w/ ATmega328. Previously, Arduino boards came with an ATmega168;
for those, select Arduino Diecimila, Duemilanove, or Nano w/ ATmega168. (Details of the board menu
entries are available on the environment page
.)
8 | Select your serial port
Select the serial device of the Arduino board from the Tools | Serial Port menu. This is likely to be COM3
or higher (COM1 and COM2 are usually reserved for hardware serial ports). To find out, you can
disconnect your Arduino board and re-open the menu; the entry that disappears should be the Arduino
board. Reconnect the board and select that serial port.
9 | Upload the program
Now, simply click the "Upload" button in the environment. Wait a few seconds - you should see the RX
and TX leds on the board flashing. If the upload is successful, the message "Done uploading." will appear