Owner's manual

PACKING LIST SECTION II: Airtec Kit Components

12 NEXTTEQ LLC (Rev. 2) 4/09

1.2 AIRTEC KIT

Your Airtec Kit includes the following components:

Regulator, Regulator Gauge, Flow Meter, Tube Holder

1.3 AIRTEC DETECTOR TUBES

The Airtec Kit is designed for use with the following Gastec Tubes:

Carbon Monoxide, Carbon Dioxide, Nitrogen Oxides, Oil Mist, Water Vapor

WARNING

Use only the Gastec tubes listed above.

Airtec detector tubes are designed to meet the monitoring requirements for maintaining

Grade D (Compressed Gas Association) breathing air. These standards are listed in Table

1 (below).

NOTE

The Airtec Kit is not equipped to monitor for oxygen deficiency. Nextteq LLC

recommends the use of a portable sample draw oxygen meter.

Table 2 (page 13) lists the data for Gastec Airtec Tubes included in the kit. Tube

packages contain detailed instruction sheets on the storage and use of the tubes, as well as

instructions on interpreting tube readings. Tubes are packaged ten per box, allowing ten

tests. Tubes may be used only once.

TABLE 1

COMPRESSED GAS ASSOCIATION GRADE D STANDARDS

Gas/Substance Level Comments

Carbon Dioxide 1000 ppm Maximum level

Carbon Monoxide 10 ppm Maximum level

Oil Mist 5 mg/m

Maximum level

Oxygen 19.5 – 23.5%

Water Vapor --- Varies with use requirements

SECTION I: Introduction