Installation Guide

35
SLATESTONE COLUMN WRAP, Cont.
The 18" Post Cap is designed to fit over the Slatestone Column if the top
course of corners ends with the screw hems attached or with the screw hems
removed.
Screw Attachment: Drive one screw per side through the bottom lip of the cap all the
way into the substrate. Be Careful to angle the Screws so they don’t run through the top
of the cap.
Do not overdrive screws.
Adhesive Attachments:
1) If the top course ends with the screw hem attached:
Place adhesive in each corner of the cap and secure. (Fig. 1).
2) If the top course of corners has the screw hems cut off, face screw each piece
1" from the top so that the cap covers the screw heads. Place adhesive on inside
cutouts as shown (Fig. 2).
Top Course with Screw Hem Attached
Adhesive
Points
Bottom of Cap
Top Course with Screw Hem Removed
Adhesive
Points
Bottom of Cap