Installation Guide

1) Fir out the desired column to 14¼" x 14¼" .

2) Starter Strip- Determine the height above ground the

bottom of the column should be. Measure up 2 3/4" from

this point and strike a level line. Attach the top of the starter

strip on this line. Level and attach starter strip on each face,

stopping 2" from each corner. (Fig. 1)

Optional: The panels can be face screwed at the bottom to eliminate

the need for a starter strip. The screw heads will need to be caulked

and painted for finished results. Paint Kit and caulk are sold separately.

3) Each box contains 4 PIECES, MARKED 1-4. Attach the male

panel (number 1). Slide down and seat panel 1 onto the starter strip and

attach on the screw hem guide points. (Fig. 2)

4) Next, place the side pieces, (number 2 and 3) into the dovetail joints

and check for tightness. From panel 1, panel 2 is on the right side, and

panel 3 is on the left side. Make sure to place all panels with the top

arrow pointing up. (fig. 3)

5) Attach panel number 4 at the base, then slide into panels 2 and 3.

Make sure joints are tight, then screw at the top using the screw hem

guide points. (Fig. 4)

6) To make columns higher than 30”, simply stack the next course us-

ing the tongue and groove attachment for the

bottom, and the screw hem at the top. (Fig. 5)

30” COLUMN WRAP INSTALL

Fig. 1

Fig. 2