Installation Guide

COUNTRY LEDGESTONE PANEL INSTALLATION, Cont.

Paneling a wall with outside corners on the right and le.

Working from the le outside corner (OC), seat the 1st panel against the OC and down

against the starter strip, connue as described in secon 1. Cut the right OC so there is

a straight rock edge and aach. Measure

the last piece on the row and cut this panel

straight to t snugly against the OC. Caulk the

joint if necessary and use touch up paint.

Work the right corner from le to right as de-

scribed in secon 1. Work the le OC as de-

scribed in secon 2.

Opon 2: (More skill required) Working from the le outside corner (OC), seat the 1st

panel against the OC and down against the starter strip, connue as described in

secon 1. Place the right OC in place for measurement. Place a weather barrier cleat

such as black tar paper, Tyvek or the equivalent to the substrate behind the joint.

Measure the last piece on the row and cut this panel using the “T” design for the male

tongue. Use an exisng panel as a template. A carpenter knife and sabre saw is

necessary. Aach against the OC and secure both pieces. Caulk the joint if necessary

and use touch up paint. Work the right corner from le to right as described in secon

1. Work the le OC as described in secon 2.

Ledgestone panels have 4 unique panel conguraons with a number, 1 through 4,

molded into the back of the panel. Avoid racking the panels by placing like numbered

panels next to or on top of each other.

The illustraon below shows a random installaon using drops from the

previous course to start each new course. If there are no drops, randomly cut the

starng panel to length.

1 2 3 4 1

1 2 3 4

1 2 3 4 1 2

2 3 4 1 2

To validate warranty, product MUST be registered. Register this product at: