Installation Guide

COUNTRY LEDGESTONE OUTSIDE CORNER

Step 1

Metal Starter Strip - Determine at what height above grade level you want

the panel to sit on. Measure up 2 ¾" from this point and strike a level line.

Aach the top of the starter strip on this line. End the strip 2" from each side

of the corner. (Fig. 1)

Step 2

Set the Ledgestone outside corner piece against the

corner and down against the starter strip. Use the screw

guides and place at least 3 screws along the tongue.

(Fig. 2)

Place 2 screws in the right lap side of the panel where

indicated. (Fig. 3)

When making mulple courses, alternate the corners

le and right to give proper oset and stagger to joints.

(Fig. 4)

Step 3

Aach the panels working out from each side of the

corner as previously described. (Fig. 5)

Note: There are 4 paerns of the Ledgestone Outside Corner. 2 Le paerns and 2 right paerns.

Check for numbers on the backside of the piece. They are numbered 1 through 4. Alternate le and

COUNTRY LEDGESTONE CORNER INSTALLATION

All products must be allowed to acclimate; removed from boxes and stored at at the

installaon site for a minimum of 48 hours or unl properly acclimated prior to

installaon. Heat and moisture cause expansion. Best results are obtained by installing

cool, dry product. NextStone does not warrant against gapping caused by expansion

and contracon.

Manufacturer does not warrant against gapping caused by

expansion and contracon.

To validate warranty, product MUST be registered. Register this product at:

WWW.StoneSidingWarranty.com

Fig. 1

Fig. 3

Fig. 4

Fig. 5

Fig. 2

Screw Points

PAGE 1
COUNTRY LEDGESTONE CORNER INSTALLATION All products must be allowed to acclimate; removed from boxes and stored flat at the installation site for a minimum of 48 hours or until properly acclimated prior to installation. Heat and moisture cause expansion. Best results are obtained by installing cool, dry product. NextStone doesdoes not warrant against gapping caused by expansion Manufacturer not warrant against gapping caused by expansion and contraction. and contraction.
PAGE 2
COLUMN WRAP INSTALL COUNTRY LEDGESTONE COLUMN WRAP 1) Fir out the desired column to 13 ¾" x 13 ¾". Fig. 6 2) Starter Strip- Determine the height above ground the bottom of the column should be. Measure up 2 ¾" from this point and strike a level line. Attach the top of the starter strip on this line. Level and attach starter strip on each face, stopping 2" from each corner. (Fig. 6) 3) Each box contains 2 left (L-2,L-4)and 2 right corners(R-1, R-3). 2 boxes are needed per 2 courses.