Installation Guide

45
Component: acgih tlv (units) Osha pel (units)
Processing Waste 5 mg / cubic meter (8 hour twa) 5 mg / cubic meter (8 hour twa)
Processing Waste 10 mg / cubic meter (stel) 10 mg / cubic meter (stel)
Section 5: REACTIVITY DATA:
Stability: Stable under normal conditions
Incompatibility
(Materials to avoid): Avoid open flame. Avoid contact with oxidizing agents. Product may
auto-ignite at temperatures in excess of 450 degrees Fahrenheit.
Hazardous decomposition products: Thermal and / or thermal oxidative decomposition can produce
irritation and toxic fumes and gasses including carbon monoxide,
hydrogen cyanide
Section 6: HEALTH HAZARD DATA:
Rigid polyurethane is not considered or listed as a hazardous chemical in 29 CFR 1910 subpart Z, Product Safety
Act (15 U.S.C. 2051), or the Federal Hazardous substances Act (15 U.S.C. 1261)
Foam dust may be a by-product of the installation process.
Ingestion: Not applicable
Eye Contact: Eye irritation possible
Skin Contact: Waste generated from processing may evoke allergic contact dermatitis in
sensitized individuals.
EMERGENCY AND FIRST AID PROCEDURES:
Eye Contact: Immediately flush with copious amounts of water. Remove to fresh air. If irritation persists, get
medical attention.
Skin Contact: Wash affected area with soap and water. If rash or persistent irritation or dermatitis occurs
seek medical attention.
Inhalation: Remove to fresh air. If persistent irritation, severe coughing or breathing difficulty occurs, seek
medical attention.
Ingestion: Not applicable
Section 7: TOXICITY DATA:
Processing Dust: May cause nasal dryness, irritation and obstructions, coughing, wheezing, and sneezing.
Sinusitis and prolonged colds have also been reported. Depending on the type, processing dust
may cause respiratory sensitization and or irritation.
Section 8: PROTECTION INFORMATION AND CONTROL MEASURES:
Respiratory protection: Dust mask, if dust exceeds allowable exposure limits wear a NIOSH /
OSHA approved respirator.
Eye protection: Safety glasses or goggles
Skin protection: None required (gloves optional)
Engineering Controls: Provide adequate general and local exhaust ventilation to most
exposures.
Section 8: PRECAUTIONS FOR SAFE HANDLING AND USE:
Release / Spill Handling: Scrap material or dust from sawing or cutting should be handled as
an inert solid, in the fashion of sand.
Waste Disposal Method: Landfill as non-hazardous waste.
Storage: Panels and accessories should be stored in original boxes to prevent
damage or deformation of the product.
Important: The information and data herein are believed to be accurate and
have been compiled from sources believed to be reliable. It is
offered for your consideration, investigation and verification. Buyer
assumes all risk of use, storage and handling of the product in
compliance with applicable federal, state and local laws and
regulations. NextStone™ makes no warranty of any kind, express or
implied, concerning the accuracy or completeness of the information
and data herein. The implied warranties of merchantability and
fitness for a particular purpose are specifically excluded. NextStone™
will not be liable for claims relating to any party’s use of or reliance