Installation Guide

CORNER INSTALLATION

All products must be allowed to acclimate; removed from boxes and stored flat at the

installation site for a minimum of 48 hours or until properly acclimated prior to

installation. Heat and moisture cause expansion. Best results are obtained by installing

cool, dry product. NextStone does not warrant against gapping caused by expansion

and contraction.

Step 1

Metal Starter Strip - Determine at what height above grade level

you want the panel to sit on. Measure up 2 ¾" from this point and

strike a level line. Attach the top of the starter strip on this line. End

the strip 2" from each side of the corner.

Step 2-Set the Stacked Stone outside corner piece against the

corner and down into the starter strip. Use the screw guides and

place at least 3 screws along the tongue. Place 2 screws in the

right lap side of the panel where indicated. (Fig. 7).

Figure 7

Step 3-Attach the panels working out from each side

of the corner as previously described. (Fig. 8)

Figure 8

Note: There are 4 patterns of the Stacked Stone Outside Corner. 2 Left patterns

and 2 right patterns. Check for numbers on the backside of each corner piece.

They are numbered 1 through 4. Alternate left and right corners with each course

to ensure offsets and to prevent pattern repetition.

STACKED STONE OUTSIDE CORNER