Installation Guide

SLATESTONE 1 & 2 PC POST COVER, Cont.

9) Attaching the Cap. Apply adhesive around the top

surface of the post. (Fig. 8) In addition, apply adhesive to

the inside top of the cap along the inside ledge. ( Fig. 9)

10) Install Rail Mounts. After locating the desired height of

the railing and securely attaching the mounts (see #5),

measure up on the outside of the post cover, and select the

spot to place the landing. In this example Trex ™ universal

mounts are used. When the landing location is decided, dry

fit the landing on the rock surface. Using a carpenter knife

or chisel, cut out the high points of the rock surface to

achieve a smooth flat surface. (Fig 10-13)

Use 3” screw

11) Using 3" deck screws minimum, attach the mount to the post,

screwing through the pillar into the landing attached in section 5.

(Fig. 14-15)

12) Finish the job using NextStone Textured Grout and Paint kit

to cover any space around the mountings and to hide screw heads .

(Grout and Touch Up Kit sold separately). (Fig. 16)

Finished Post and Cap

(Fig. 16)

(Fig. 15)

(Fig. 14)

(Fig. 13) (Fig. 12) (Fig. 11) (Fig. 10)

(Fig. 9)

(Fig. 8)