Installation Guide

37
RANDOM ROCK COLUMN WRAP, Cont.
The 18” Post Cap is designed to fit over the Random Rock Column if the top
course of corners ends with the screw hems attached.
Adhesive Attachments:
To set the cap, a slight modification is required.
1) Place the cap on a soft surface to prevent marring the top
of the cap. (Fig. 1)
2) Using a chisel or carpenter’s knife, remove the 4
corner landings (Fig. 2)
3) After the landings are removed, dry fit the cap to make sure it sits properly.
4) Use adhesive on the 4 modified landing points to secure the cap. (Fig 3)
Adhesion
points
(Landings
Removed)
Fig. 1
Fig. 2
Fig. 3
Column with Cap installed
Landings removed