Installation Guide

32
30" COLUMN WRAP, Cont.
Top Course with Screw Hem Attached
Adhesive
Points
Bottom of Cap Fig. 1
Top Course with Screw Hem Removed Bottom of Cap fig. 2
Adhesive
Points
The Sandstone 18" Column Wrap Cap is designed to fit the Slatestone Col-
umn with or without the screw hems.
Screw Attachment: Dr ive one screw per side through the bottom lip of the
cap all the way into the substrate. Be Careful to angle the Screws so they don’t
run through the top of the cap. Do not overdrive screws.
Adhesive Attachments:
1) If the top course ends with the screw hem attached: Place adhesive in each
corner of the cap and secure. (Fig. 1).
2) If the top course of corners has the screw hems cut off, face screw each piece
1” from the top so that the cap covers the screw heads. Place adhesive on inside
cutouts as shown (Fig. 2).