User's Manual

Document Name: WAPS Beacon NOC User Manual
Document No: JGR-NN-OP-102.00-Rev1.2
Version No: 1.2
Company Name: NextNav, LLC. Page 4 15-Nov-12
Page 4 of 7
1 Introduction
1.1 Purpose and Scope
This document includes the information of the NextNav WAPS Beacon system A4P-100-0007-01
that is required for the network deployment and Network Operations Center (NOC) operator.
2 Product specification
The WAPS beacon system is intended to be used in restricted access locations (RAL) in indoor
and outdoor environments under all weather conditions. The WAPS beacon is a powered by
power system, and is provided with four 12 volt batteries (providing 48VDC) approved for use in
telecommunications equipment.
WAPS Operating Temperature: -40 Deg C to +50 Deg C operating
Storage temperature: -55 Deg C to +80 Deg C
Humidity: 90% non-condensing.
WAPS weight: 100 lbs.
Power rating: 120VAC, 60Hz, 4 AMP
3 Equipment List:
• NextNav WAPS Beacon
• NextNav Power System
• Antenna
– Transmit Omni
– GPS : L1 GPS (BL1R-A-XTB-1-FKM)
• Cables
– TX antenna cable: As per chart below:
Main Feed
Length
Cable Type
Jumper Top
Jumper Bottom
<50’
LDF4 (1/2”)
None
None
51’-130’
LDF5 (7/8”)
None
None
131’ -250’
LDF 7 (15/8”)
½” X10’
½” X 6 ft
– GPS antenna Cable: (not to exceed 100 feet)
GPS cables are pre-fabbed and available in three lengths: 25’, 50’ and 100‘. The
cable is an LMR 240 or equivalent (1/4”) and is pre-terminated with mating ends
N male for connection to the beacon and TNC Male for the antenna end.