User's Manual

Using your Bluespoon™ SPIDER
Charging: Before you can use the Bluespoon™ SPIDER, you need to charge it.
A. USB (computer) charging
cable
B. AC (wall) charger
C. iGo* adapter
FIG.2
There are two ways of charging the Bluespoon™ SPIDER, by USB charging cable or by using the AC charger.
1) Connect the small end of, the USB charging cable, an AC charger or an iGo* adapter, to the Bluespoon™ SPIDER.
2) Connect the other end of the charger into an electrical outlet (computer USB port or Wall plug).
While charging, the RED light (located underneath the joystick) will be lit. Refer to “Light indicator table” for more information.
3) Once the Bluespoon™ SPIDER is fully charged (approx 90 minutes), the RED light turns off.
Please note if charging is done by USB, the charging time will be longer if the computer is in standby/sleep mode.
4) When the charging is complete, remove the power supply from the electrical outlet.
5) Remove the USB charging cable, the AC charger or the iGo* adapter from the Bluespoon™ SPIDER.
The fully charged Bluespoon™ SPIDER provides:
• Stereo streaming time, up to 11 hours
• Talk time on cell phone, up to 10 hours
• Standby time, up to 1000 hours
The above time specifications are measured with a range of 33 ft. between devices.
Please note that if ranges between devices are longer, the time specifications will be shorter.
6) When the battery is discharged, the warnings tones could be heard each 30 sec. (If the Bluespoon™ Spider is turn on)
Turning the headset ON:
Press and hold the joystick for approximately 3 seconds.
The blue indicator light will flash once.
Turning the headset OFF:
Press and hold the joystick for approximately 4 seconds.
The red and blue indicator light will flash once at the same time.
Pairing:
Bluetooth® devices are connected to each other by what is known as “Pairing”. Once devices are paired, they will recognize each other
whenever they are reconnected.
Pairing your Bluespoon™ SPIDER with another Bluetooth® enabled device (e.g. cell phone, computer):
1) Turn off your Bluespoon™ SPIDER if it is ON.
2) Press and keep holding the joystick until the red and blue indicator light (located underneath the joystick) flash repeatedly.
The Bluespoon™ SPIDER will now be in the pairing mode for 3 minutes.
3) By using your cell phone or another Bluetooth® enabled device’s Bluetooth® menu, you can start to search for the Bluespoon™
SPIDER. (For the details on device paring please refer to the cell phone user’s guide, PC/MAC software or USB dongle software user
guide).
4) When the search is complete, the name of the Bluespoon™ SPIDER will appear as “Bluespoon™ SPIDER” on the display of your cell
phone, PC/MAC or another Bluetooth® enabled device.
5) When asked for a passkey, please enter: 0000.