User's Manual

The minimum safe distance for people from this module has been determined by conservative calculation to be 20 cm for all allowable
antenna types. The end product User’s Manual must include the following statement in a prominent location: (Note for modules with RF
output power <10mW, this statement is likely not required).
To comply with FCC’s RF radiation exposure requirements, the antenna(s) used for this transmitter must be installed such that a
minimum separation distance of 20 cm is maintained between the radiating element (antenna) & any user’s or bystander at all times
and must not be co-located or operating in conjunction with any other antenna or transmitter.
 Industry Canada Statement
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre
le fonctionnement.
 End Product User Manual
The end product user manual shall include all required regulatory information/warning/note as show in this instruction.
Information to the end user regarding how to install or remove this module shall not be provided in the end product user manual.
 End Product Labeling
1) The final end product must be labeled in a visible area with the following:
US FCC:
Contains FCC ID: YETMBLE
Canada IC:
Contains IC: 9298A-MBLE
V1.1 2 of 2 FCC4_Integration Instructions_Module