User's Manual

Nextivity Inc Headquarters:
12230 World Trade Drive
Suite 250 San Diego, CA 92128, USA
http://www.nextivityinc.com
Bureau in Europe:
Whitehill Way, Swindon, UK SN5 6QR
Nextivity Inc Headquarters:
12230 World Trade Drive
Suite 250 San Diego, CA 92128, USA
http://www.nextivityinc.com
Bureau in Europe:
Whitehill Way, Swindon, UK SN5 6QR
PI_PRO-NA-English_14-1104 PI_PRO-NA-English_14-1104
dential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no guar-
antee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equip-
ment and receiver.
• Connect the equipment into an outlet on a cir-
cuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help
Industry Canada (IC) Statement
The Manufacturer’s rated output power of this
equipment is for single carrier operation. For situ-
ations when multiple carrier signals are present,
the rating would have to be reduced by 3.5 dB, es-
pecially where the output signal is re-radiated and
can cause interference to adjacent band users.
This power reduction is to be by means of input
power or gain reduction and not by an attenuator
at the output of the device.
This device complies with Industry Canada
license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this
device may not cause interference, and (2) this
device must accept any interference, including
interference that may cause undesired operation
of the device.
Gain 100dB
Bandwidth 35Mhz
Input and Output
Impedances
50 ohm
Output
Power
Uplink 22dBm per band
Downlink 16dBm per band
Le présent appareil est conforme aux CNR
d’Industrie Canada applicables aux appareils
radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes : (1)
l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout
brouillage radioélectrique subi, même si le brouil-
lage est susceptible d’en compromettre le fonc-
tionnement.
Compliance Contact
In the event of regulatory compliance issue,
please contact Nextivity Inc. directly. Contact in-
formation is available at www.nextivityinc.com.
Patents
This product is covered by Nextivity, Inc., US
patents and patents pending. Please refer to
CEL-FI.com for details.
Copyright
Copyright © 2014 by Nextivity, Inc. All rights re-
served. Reproduction or media conversion by any
means is protected by copyright and may only oc-
cur with prior written permission of Nextivity. De-
signed by Nextivity in California.
dential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no guar-
antee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equip-
ment and receiver.
• Connect the equipment into an outlet on a cir-
cuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help
Industry Canada (IC) Statement
The Manufacturer’s rated output power of this
equipment is for single carrier operation. For situ-
ations when multiple carrier signals are present,
the rating would have to be reduced by 3.5 dB, es-
pecially where the output signal is re-radiated and
can cause interference to adjacent band users.
This power reduction is to be by means of input
power or gain reduction and not by an attenuator
at the output of the device.
This device complies with Industry Canada
license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this
device may not cause interference, and (2) this
device must accept any interference, including
interference that may cause undesired operation
of the device.
Gain 100dB
Bandwidth 35Mhz
Input and Output
Impedances
50 ohm
Output
Power
Uplink 22dBm per band
Downlink 16dBm per band
Le présent appareil est conforme aux CNR
d’Industrie Canada applicables aux appareils
radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes : (1)
l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout
brouillage radioélectrique subi, même si le brouil-
lage est susceptible d’en compromettre le fonc-
tionnement.
Compliance Contact
In the event of regulatory compliance issue,
please contact Nextivity Inc. directly. Contact in-
formation is available at www.nextivityinc.com.
Patents
This product is covered by Nextivity, Inc., US
patents and patents pending. Please refer to
CEL-FI.com for details.
Copyright
Copyright © 2014 by Nextivity, Inc. All rights re-
served. Reproduction or media conversion by any
means is protected by copyright and may only oc-
cur with prior written permission of Nextivity. De-
signed by Nextivity in California.