User's Guide

Uplink output power configuration
In this section, you will learn how to set a value for the output transmit power to reach the high-site
without blocking the receiver. Two pieces of information are required to determinate the most optimal
value. Decimal coordinates from both the high-site and QUATRA RED and the desired signal level
reaching the remote site (the default value is -95dBm).
1. Open the WAVE PRO app and select "Uplink output power configuration."
2. Enter the coordinates of the remote site
3. Enter the coordinates of the building
4. Enter the desired value in dB to reach the high-site
5. Press the "Calibrate" button and wait until you see the message "System has been calibrated."
Band configuration (FirstNet)
This section applies only to QUATRA RED units that support FirstNet bands (Model number F42-10C-
78F and F42-10N-78F).
There are two ways to select the LTE/FirstNet band to be repeated; you can either relay on the system to
choose the band with the best signal strength and quality or manually select the desired band to boost.
Selecting the band via the WAVE PRO app
1. Open the WAVE PRO app and select "Network Settings."
2. Click on "Band configuration" and select "Auto" The system will automatically choose the band
to be repeated.
3. Click on "accept" and continue with the commissioning process.
Selecting the band manually
1. Open the WAVE PRO app and select "Network Settings"
2. Click on "Band configuration" and select "Manual"
Channel configuration (LMR)
Alarms configuration and test
LEDs