User's Guide

9/10/2019
30
Figure 21. Alarm Cable Configuration
RA user interface
The table below shows the color coding for any alarm condition in the Remote Annunciator. LEDs will be
OFF if there is no alarm. If an alarm is present LEDs will be RED.
If there is a communications fault (open, shorted to ground or disconnected cable) between the Fire Alarm
Control Unit and the Remote Annunciator Panel, the LEDs will flash.
Normal OK Status
Alarm
Communications Fault
Normal AC Power
Off
Red
Red - Flashing
Loss of normal AC
power
Off
Red
Red - Flashing
Battery Charger Fail
Off
Red
Red - Flashing
Low Battery Capacity
Off
Red
Red - Flashing
Donor Antenna
Disconnection
Off
Red
Red - Flashing
Active RF Emitting
Device Malfunction
Off
Red
Red - Flashing
System Component
Malfunction
Off
Red
Red - Flashing
Donor Antenna
Malfunction
Off
Red
Red - Flashing
Figure 22. LED panel configuration