Operation Manual

 ENG237
DVD
Problem Solution
Battery will not charge Ensure the main power switch is set to OFF / CHARGE
and an external power supply is correctly connected.
Check the GREEN / RED battery indicator on the player
illuminates. If the problem persists then a battery fault may
be present, contact the NEXTBASE Authorised Service
Centre.
Player runs on battery, but for a
short time only
Fully discharge the battery.
Recharge fully by connection to power supply and setting
power switch to OFF / CHARGE position. Wait until
GREEN charge indicator illuminates.
Battery is exhausted; contact the NEXTBASE Authorised
Service Centre.
Player will not play a DVD and
shows “Wrong Region.”
The region code of the disc inserted does not match the
authorised region of the player.
Perform a RESET to the default settings, to reset the DVD
player to multiregional. See the SETUP section of this
manual under PREFERENCES and then RESET to the
default settings.
ZOOM remains on-screen
whenever this function is selected.
This is normal and NOT a defect. During the zoom
function, the FFWD, REV, PREV and NEXT do not work as
the control is for the Up, Down, Left and Right Position of
the Zoomed image. The ZOOM label remains on-screen to
remind you of this fact. Exit the zoom function to enable the
normal FFWD, REV, Prev and NEXT function once again.