Owner's Manual

ATO/C Type
(ordinary)
ATM Type (mini)
ATO/C & ATM fuses. 2 Amp.
Supplied Amp fuse location
Original fuse location
Positive (+) fuse tap cable bullet connector
5V Mini USB connector
12-24Vdc to 5Vdc regulator
Negative (-) spade connector
Positive (+) car power cable bullet connector
LED indicator
Camera Power Cable
Warnings:
- Failure to use the supplied installation parts
and/or hardware will void the product warranty.
- Failure to connect the product as instructed may
result in discharge of the vehicle battery.
- Failure to follow these safety precautions and
instructions could result in damage to the product
and/or vehicle, which will not be covered under the
product warranty or the manufacturer’s warranty.
Safety Precautions:
- Perform the installation with the ignition in the
OFF position.
- Do not strip any live wires.
- Correct electrical polarity and grounding is
required for safe and proper installation.
- Only connect to a negative ground DC supply
circuit.
- Not for installation to positive ground circuits.
Hardwire Kit
For use with all Nextbase™ Dash Cam models. These instructions provide the necessary
information to install the Dash Cam Hardwire Kit properly and safely within your vehicle.
Before beginning the installation process, please read these instructions carefully. It is
recommended for normal journey video recording, the Hardwire Kit is connected to a
switched’ power supply. This means that power is supplied to the Dash Cam ONLY when
the vehicle’s ignition is turned on. A permanent live (un-switched) connection is only
required when the Dash Cam is to be used when the vehicle is not in use, i.e. for
surveillance purposes. The Dash Cam will operate normally until the vehicle’s battery
drops below the minimum voltage cut-off level; this minimum voltage cut-off is 11.0Vdc
for a 12Vdc battery and 23.0Vdc for a 24Vdc battery. This protects the vehicle’s battery.
If in any doubt, please consult a vehicle technician prior to starting installation.
09
2
5
1
2
5
3
1
4
3
4
1
2
4
6
7
8
7
8
6
9
9
3
9
Suitable for:
Fuse Tap Cables
Note: For Micro (Low Profile Mini) Fuses, see item 1.3 overleaf.
622
GW