Owner's Manual

Table Of Contents

Adjusting the Polarising Filter:

1The most effective way to set up your Polarising Filter ( ) is to place a piece of plain white paper

( ) on your dashboard ( ) under the rear view mirror. With your camera turned ON you will see 2 3

the reflection ( ) of the paper in the LCD screen of the Dash Cam. Look at the reflection ( ) on the 4 4

windscreen through the Dash Cam display ( ).5

Gently rotate the front bezel to adjust the

filter. Rotate the filter until the windscreen

reflection is as hidden as possible on the

Dash Cam display (see below).

Once the reflection can no longer be seen,

operate the Dash Cam normally. Please

note; it may not be possible to fully remove

the reflection, but using the Polarising Filter

will noticeably improve your video quality.

Polarising Filter/Reﬂection Free Lens

The Polarising Filter is designed to reduced the glare on your windscreen as seen through

the Dash Cam, allowing you to record the road ahead clearly. In bright sunlight the filter

will also enhance the colour and contrast levels to help capture important number plate

details. The 522GW and 622GW Dash Cam model already have a built-in polarising filter.

The above diagram is for illustration purposes only.

MODE

Do not place fingers on the glass lens of the filter.

Do not adjust the filter while in control of the vehicle

Suitable for:

Remove the adhesive layer on the back of the Polarising Filter, and apply the filter to the front of

the Dash Cam lens, making sure that the text (”140° Wide Angle Lens”) is at the top of the lens.

Also ensure that you remove the protective layer over the lens before using your Dash Cam.

622