User Manual

With this switch off ( ), each channel feeds both the left and right sides of the main mix equally.
For example:
• Playing a mono source: If you talk into a microphone connected to input 1, your voice will be
heard in both the left and right loudspeakers.
With this switch pressed in ( ), channel 1 will play only in the left side of the main mix, and channel 2
will play in the right side.
For example:
• Recording a stereo source: If you have a stereo microphone connected to the mic inputs, or if you
are playing a stereo source into the line inputs, each side of the source can be recorded discretely
onto a recorder connected to the main outputs.
The STEREO switch does not affect channels 3/4, USB playback nor Bluetooth.
9. Stereo Switch
10. Microphone/AUX[ ]Input Jack
Headphones[ ]Output Jack
Connect a 3.5mm audio jack to your headphones or headset.
Connect a 3.5mm audio jack from your microphone, headset or mobile audio device.
The audio input here is sent to channel 1.
13. Phones Knob
Used to adjust the volume of the output of the headphones [ ] connected to the 3.5mm jack.
Used to adjust the output signal level of the [MAIN] output.
14. Main Knob
11. Line In, USB and Bluetooth Control Knobs
Please refer to the function description and control ofand .
6 8
For input switching between USB/Bluetooth and Line In on channels 3/4.
18. CH3/4 Input Switch Button
12. PC USB 2.0 Playback Knob/Button
Used to adjust the volume of the input signal from the device connected to the [USB 2.0] port.
«TO MAIN» Button
This switch is used to play signals from the PC USB sources. To send the PC USB signal to the main
channel, the button MUST be pressed down (). Otherwise the sound will play on headphones only.
7
15. FX Knob
Used to adjust the effects volume level from the internal effects processor.
16. Level Meter LED
The L and R meters show the volume level of the output signal from the [MAIN] output sockets. in
The values are showed in six levels."CLIP", "0"dB, "-6"dB, "-20"dB. Try to keep it at 0dB or below.
If the "CLIP" glows red continuously, turn the [MAIN] knob to the left to lower the output volume level.
17. USB
Used to connect a USB flash drive (FAT32 or exFAT).
Supported Formats: MP3 or WAV/WMA/FLAC.
EN