User Manual

Followtheimportantprecautionsbelow,inordertopreventnoiseand possible
damagetoexternaldevicesaswellasthemixerifyouturnthis switchon( ).
1. Besuretoleavethisswitchoff ( ) when youdon’t need phantom power (+48V)
on both channel1 or channel 2.
2.Makesuretoturnthisswitchoff ( ) whenconnecting/disconnecting acable
to/fromchannel1 or channel 2.
3.Reduce the gainonboth channelstominimumbeforeturningthisswitchon( ) / off( ).
Whenthisswitchisturnedon( ), the [+48V] LEDlightsand DC +48Vphantom
powerissuppliedtotheXLRplugonMIC/LINEinputs. Turnthisswitchonwhen
usingapowered condensermicrophone or +48V active DI BOX (Refer to the DI
box Owners Manual for specific power requirements.)
3. Phantom Power/+48V LED(CH1/2)
This switch will apply an high-pass filter that attenuates frequencies below 100Hz in the
signal by a slope of 12dB/octave.
2. Low Cut Button
The signal sensitivity of the channel inputs can be adjusted. For gain matching, the stereo inputs
feature a GAIN switch which selects between High and Low gain.
5. Gain Knobs/Button
6. EQ Knobs
These buttons turn on the effects on the desired channels, adding a natural spaciousness
to the sound. The default settings have the effects turned off.
7. FX Buttons
It is used to connect the USB power adapter and type-C data cable to supply power
to the mixer.
1. Power Input Socket [TYPE-C]
6
Use [HIGH], [MID] and [LOW] knobs to adjust sound equalization. For no sound equalization,
set all knobs to "0" (flat).
8. Level Knobs
Used to adjust the volume of their respective channel signal.
Note: To minimize noise, adjust the knobs on unused channels to a minimum.
Note
• Read carefully the safety precautions for the USB power adapter and type-C
data cable you are using.
• USB power adapter and TYPE-C data line Voltage standard:
Output Voltage: 4.8V to 5.2V | Output Current: 2A or higher
To connect a guitar directly to the mixer without using a DI Box, press this switch first ( ) then
connect the output from the guitar to the channel1 TRS input. The input impedance is optimized
for direct connection and high-frequency fidelity is assured. In the off ( ) position, the channel1
TRS input becomes a line input just like the other mono line input. To use guitars or other
instruments on other channels, you will need to use an external DI box first.
Without the DI box, or if this switch is not pressed in, guitars may sound dull and muddy.
4. HI-Z (CH1)
EN