User Manual

2
■
■
XLR-type connectors are wired as follows (IEC60268 standard): pin 1: ground, pin 2: hot (+), and pin 3: cold (-).
NOTICE
To avoid the possibility of malfunction/ damage to the product, damage to data, or damage to other property, follow the
notices below.
Handling and maintenance
Do not use the device in the vicinity of a TV, radio, stereo equipment, mobile phone, or other electric devices. Otherwise,
the device, TV, or radio may generate noise.
Do not expose the device to excessive dust or vibration, or extreme cold or heat (such as in direct sunlight, near a heater,
or in a car during the day), in order to prevent the possibility of panel disfiguration, unstable operation, or damage to the
internal components.
Do not place vinyl, plastic or rubber objects on the device, since this might discolor the panel.
When cleaning the device, use a dry and soft cloth. Do not use paint thinners, solvents, cleaning fluids, or chemical-
impregnated wiping cloths.
Condensation can occur in the device due to rapid, drastic changes in ambient temperature—when the device is moved
from one location to another, or air conditioning is turned on or off, for example. Using the device while condensation
is present can cause damage. If there is reason to believe that condensation might have occurred, leave the device for
several hours without turning on the power until the condensation has completely dried out.
Avoid setting all equalizer controls and faders to their maximum. Depending on the condition of the connected devices,
doing so may cause feedback and may damage the speakers.
Do not apply oil, grease, or contact cleaner to the faders. Doing so may cause problems with electrical contact or fader
motion.
When turning on the AC power in your audio system, always turn on the power amplifier LAST, to avoid speaker damage.
When turning the power off, the power amplifier should be turned off FIRST for the same reason.
Connectors
INFORMATION / WARRANTY
Because of the continuous evolution of techniques and standards, NEXT Audiocom reserves the right
to change the specifications of its products without warning. For the most updated version of this manual
and general information about this and other products, please visit our website www.nextaudiocom.com.
NEXT Audiocom products are warranted, by NEXT Audiocom, against manufacturing defects in materials
or craftsmanship over a period of 2 years counting from the date of original purchase for final customer.
The original receipt of purchase is mandatory for warranty validation purposes, and the product must have
been bought from a NEXT Audiocom authorized dealer. The warranty can be transferred to a subsequent
owner during the warranty period, however, this cannot extend the warranty period beyond the original warranty
period of two years from the original date of purchase stated on the NEXT Audiocom’s invoice.
During the warranty period NEXT Audiocom will, at its own discretion, either repair or replace a product which
prove to be defective provided that the product is returned in its original packaging, shipping prepaid, to an
authorized NEXT Audiocom service agent or distributor. NEXT Audiocom cannot be held responsible for defects
caused by unauthorized modications, improper use, negligence, exposure to inclement weather conditions, act of
God or accident, or any use of this product that is not in accordance with the instructions provided by this manual
and/or NEXT Audiocom. NEXT Audiocom is not liable for consequential damages. This warranty is exclusive, and no
other warranty is expressed or implied. This warranty does not affect your statutory rights.
EN