User Manual

Table Of Contents

TECHNICAL SPECIFICATIONS

Input Channels:

Mono: 2 x XLR/TRS Combo

Stereo: 1 x RCA Line, USB, Bluetooth

PC: 2 x Audio Inputs

Input Channels Functions: HI-Z, Low Cut, EQ (LOW, MID, HIGH), Effects

Phantom Power Voltage: +48V

Output Channels:

Main: 1 x TRS Stereo Output

Headphones: 1 x 3.5mm audio jack

PC: 2 x Audio Outputs

USB Audio Technology:

Sampling Frequency: Max.: 192kHz

Bit-Depth: 24-bit

Bluetooth Technology: Stereo Bluetooth v5.0 | 10m range

Power Supply: 5V / 2A | Power Consumption: Max. 10W

Operating Temperature: 0ºC to +40ºC

Dimensions: 153mm x 64mm x 175mm (6.02" x 2.52" x 6.89")

Net Weight: 0.6kg (1.3lb)

TROUBLESHOOTING

Problem: The M1 doesn’t turn on.

Solution: Check if the power cable is well connected. Check if the power adaptor or other power source

you are using is 5V / 2A.

Problem: No sound.

Solution: Check if the the audio sources such as microphones or others, are properly connected. Check

the channel gain and volumes.

Check the MAIN level, if the output meter shows signal, check the connected output device such

as active speakers.

If you are using the USB 2.0 connection be sure the «TO MAIN» button is pressed.

Problem: No sound from microphone.

Solution: Check if it is a condenser microphone, if so, be sure to use a XLR cable and enable +48V.

Problem: No sound from USB stick, Bluetooth or Line.

Solution: Check the «CH3/4 Input Switch Button» is correctly selected according to the input needed.

Problem: Sound is faint, distorted or noisy.

Solution: If the CLIP LED is lit, reduce the gain of the input channels and/or reduce the MAIN level.

If you are you using channel 3/4 with line, bluetooth or USB, check if the GAIN button is set to LOW.

If you are using the USB 2.0 connection reduce the volume level on the computer.

Problem: The sound of vocals and speech isn’t clear enough.

Solution: Ensure the microphone is connected to channel 2 and the LOW CUT Button is activated.

Reduce the effect level if applicable.

Problem: No effect is applied.

Solution: Ensure the channel corresponding FX button is pressed and the FX level knob is not at minimum.