User Manual

Table Of Contents

When connected to a computer the M1 works exactly the same as a soundcard. You can use the computer

both as a playing or a recording device.(Thesignalis notaffectedbythe[MAIN].)

20. PC USB 2.0

21. MIC/LINE

Only these channels use unbalanced RCA interface (Line Input) to connect stereo

line signals, such as TAPE player, CD player, MP3 player, TV, etc.

Use as a Stereo input for connecting to line-level devices such as an electric keyboard

or other audio devices.

22. Line Input (Channels 3/4)

23. Main Outputs

These are balanced TRS output connectors for the mixed stereo signal.

Connect to the power amplifier that drive your main speakers or directly to active speakers.

Forconnectingtoamicrophone,aninstrument,oranaudio device.Theseconnectorssupport

bothXLRand1/4" TRS (balanced)plugs.

XLR 1/4" TRS

RECORDING TO A USB STICK

1. Insert the USB stick (FAT-32 or ex-FAT) on the USB slot.

2. Press down the FX/USB button. The LED will light up. Now the «Selector» is in USB mode.

3. Press the MODE button succesively until the recording icon starts flashing (microphone icon).

4. While the recording icon is flashing, click down on the «Selector». The icon goes solid, you are now on

recording mode. (Refer to «Operation Instructions» on page 8 for further information).

BLUETOOTH PLAYER

1. Press down the FX/USB button. The LED will light up. Now the «Selector» is in USB mode.

2. Press the MODE button succesively until the bluetooth icon starts flashing.

3. While the bluetooth icon is flashing, click down on the «Selector». The icon goes solid, you are now on

bluetooth mode.

4. Turn on Bluetooth on your player and search for devices

5. Select “NEXT M1” to pair with the mixing console - PIN “2020”

NOTE: Only one device can be paired at a time. (Refer to «Operation Instructions» on page 8 for further information).

To unpair, press and hold the MODE button.

CONNECT TO PC AS A SOUNDCARD

1. Connect the power supply to the M1 mixing console

2. Use a USB cable to connect the M1 to the PC.

3. If the audio doesn’t automatically change to the mixer, select the M1 mixing console among the PC audio devices

(3- Soundprese HD Microphones). You can choose the audio quality: 24-Bit / 44.1kHz, 48kHz, 96kHz or 192kHz.

4. Adjust the PC output sound to 60% of the volume, otherwise the sound will be distorting even at low levels.

PLAYING FROM A USB STICK

1. Insert the USB stick (FAT-32 or ex-FAT) on the USB slot.

2. Press down the FX/USB button. The LED will light up. Now the «Selector» is in USB mode.

3. Press the MODE button succesively until the USB player icon starts flashing (USB icon).

4. While the USB player icon is flashing, click down on the «Selector». The icon goes solid, you are now on

USB player mode. (Refer to «Operation Instructions» on page 8 for further information).