Table of Contents Warning......................................................................................................................................................... 1 Safety precautions....................................................................................................................................... 1 Introduction.................................................................................................................................................. 1 1.
Warning Please turn off the power when inserting or removing any memory card. Otherwise, it may cause damage to the memory cards and the unit. Safety precautions 1) Use only the supplied adaptor with Input 100-240V, Output 12V. 2) Turn off power before cleaning. Use only a soft cloth to clean the unit. Do not use liquid cleaners. 3) Avoid exposing the unit to extreme heat. 4) Do not disassemble the Digital Picture Frame, otherwise it may result in electric shock and void your warranty.
Product Diagram A. Top View Button 1. Press to pause or resume playback.Press the button longer to turn on and turn off the power. Button 2. Press to see the next picture. Button 3. Press to see the previous picture. B. Front View 4. Rotate Button Press to rotate picture during PLAY mode.Press to adjust the timing of slide show function during PAUSE mode. 5. MODE Button Press to change the aspect ratio between Pan Scan, Fill, Original, Auto Fill, Height Fill and Width Fill during PLAY mode.
Using Your Digital Picture Frame Install the stand for tabletop display. Connect the AC adaptor. Insert a memory card in the Digital Picture Frame (with the card’s electrical contacts towards the front of the unit.). A slide show will begin automatically. button. The word Pause will appear on the screen briefly and the slide show will be stopped. Press the The current photo will remain on the screen until the button is pressed again, at which time the slide show will resume. button.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device does not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. FCC Compliance This device complies with Part 15 of the FCC Rules.
