Instruction Manual

[e-mail]
Video Instruction: bit.ly/nlrbuild
PARTS:
1 X CONNECTOR BRACKET
2 X M8 NUT
2 X M8 WASHER
2 X 65MM M8 BOLT
TIPS:
Line connector bracket up with
holes in 40x40
06
Line the holes on the connector bracket with the pre-drilled holes in the 40x40 extrusion then bolt
through the bracket and holes with 2x M8 65mm bolts, washers and the nuts.
PARTS:
2 X T-NUT
05
Slide 2 x T-nut into the bottom channel of the extrusion
PARTS:
1 X KEYBOARD CONNECTOR BRACKET
1 X 65MM M8 BOLT
1 X M8 WASHER
1 X M8 NUT
1 X 35MM M8 BARREL SPACER
07
Line up holes on the Keyboard connector bracket with the holes on the connector bracket previously installed in
Step 06 and install a barrel spacer between the holes. Bolt through the lined up holes and secure with a nut
04
PARTS:
1 X 40X40 EXTRUSION
2 X M8 WASHER
2 X 65MM M8 BOLT
2 X M8 NUT
TIPS:
The aluminium extrusion has 2
pre-drilled holes
Line up pre-drilled holes on the 40x40 extrusion with the holes on the bracket previously installed in
step 03B, bolt through and secure with a nut.