Installation Guide

[e-mail]
www.nextcenturymeters.com
V. 091520
A - RR4-TR Remote Reader
E - Box Mount Screws #6-32
B - Mounting Plate
F - Wire Security Assembly
C - Sheetrock Anchors
G - Security Seal Tabs
D - Wall Mount Screws #6-20
5| In-Field Installation
5.1 – Detach from Mounting Plate
● Pull down the security tab, the Remote Reader can
then be pulled off the mounting plate.
● Slide the security tab back to its original position
when installation is complete.
DO NOT open the Remote Reader unless replacement of the
battery is necessary (approx. every 10 years). It is not necessary
to disassemble/open a Remote Reader during installation.
5.2 – Mounting Plate Installation
● Hold the mounting plate at the desired height and use
the integrated level to straighten.
● Use a pencil to mark holes for pre-drilling
● Pre-drill using a 7/32” (5.5mm) drill bit
● Insert plastic anchors and attach the mounting plate
with a PH-1 screwdriver and the two screws (fig. 4-D).
5.3 – Wall Box (optional)
● Pass the meter wire(s) through the mounting plate
access holes
● Use a PH-1 screwdriver and the two screws (fig. 4-E)
to attach the mounting plate
5.4 – Meter Wiring
The Remote Reader can be connected to one or two meters. Use
Meter 1 (left 3 terminals) and Meter 2 (right 3 terminals) to
connect meters to the Remote Reader’s mounting plate.
● Strip meter wire ends to 3/16” (5 mm)
● Insert the wire ends into the terminal block and
tighten securely using a PH-1 screwdriver
5.5 – Meter Wiring Diagram
5.6 – Tamper Evident Seal
● The Security Tab Seal (figure 4-F) or Security Wire
Seal (figure 4-G) can be used according to your
installation specifications.
6| Configuration Programming Methods
6.1 – Cloud Configuration
● Performed using the NextCentury Website or Mobile
App
● Use this configuration method when a Cloud-
connected Gateway and Repeaters have already been
installed.